Calibration levels
Our calibration services are performed at any of our service centres or on-site. As a supplier, we are certified according to ISO 9001 and our accredited laboratories are accredited by Accreditation Bodies according to ISO/IEC 17025.
Our services are designed to help you as a customer to fulfil the requirements that have been put on maintenance and calibration of your measuring instruments. All the services provide metrological confirmation of the measuring instrument that fulfils the requirements in standards as ISO 9000 and ISO 10012.
Accredited CalibrationWhen you need measurement results and evidence that the measuring instrument comply with specification. This service gives and internationally recognized calibration and fulfils the requirements for calibration according to ISO/IEC 17025. e.g to fulfil the requirements in QS 9000 and ISO/TS 164949. Metrological confirmation:
|
Calibration + measurement resultsWhen you need evidence that the measuring instrument comply with specification. This service fulfils the requirements in ISO 9000 and ISO10012. Metrological confirmation:
|
|
The calibration usually covers the complete specified range, but can be customized to your needs3. Measurement points are selected in accordance with the manufacturer's performance test or equivalent.
The measurement procedures and the test equipment are selected to ensure traceability to national and international standards.
The uncertainty of measurement is accounted for when performing a compliance or non-compliance test. If the measuring instrument does not comply with the specification after adjustment or repair is needed, the customer is contacted before any further action.
(1) When adjustments are performed, measurement results are reported for the actual points.
(2) You can order not to perform any adjustments, e.g. for reference equipment where calibration history is important.The measuring instrument is then shipped, no matter if it comply with the specification or not.
(3) The complete specification refers to relevant parts of the specification.When performing accredited calibrations, where not all of the parameters are covered by the accreditation, the calibration will be complemented by non-accredited measurements to cover the complete specification.When the complete specification cannot be covered, the equipment is labeled "Limited calibration".
